![]() ![]() ![]() Also, set the privilege level for that slot when accessed over LAN (channel 1) to ADMIN (level 4). (Note that for IPMI v1.5 the user name and password can be at most 16 characters). In the example above, there are 20 possible slots, and the first unused slot is number 4.Īssign the desired administrator user name and password and enable messaging for the identified slot. ID Name Enabled Callin Link Auth IPMI Msg Channel Priv LimĢ root true false false true ADMINISTRATORġ2 default true true false true NO ACCESS Note that some slots may be reserved and not available for reuse on some hardware. List the account slots on the BMC, and identify an unused slot less than the maximum ID and not listed, for example, ID 4 in the following example. ![]() For example: # ipmitool -I bmc lan set 1 auth ADMIN MD5,PASSWORD Set BMC to require password authentication for ADMIN access over LAN. Note that the specified address ( 192.168.0.55) is associated only with the BMC, and does not respond to normal pings.Įstablish an administration account with a username and password, using the following procedure (assuming the channel is 1): # ipmitool -I bmc lan set 1 defgw ipaddr 192.168.0.1 For example, assuming the channel is 1: # ipmitool -I bmc lan set 1 ipaddr 192.168.0.55 ![]() You must set not only the IP address, but also the proper values for netmask, and the default gateway. If the BMC shares a network connection with ILOM, then the IP address must be on the same subnet. For example, where the channel is 1: # ipmitool -I bmc lan set 1 access onĬonfigure IP address settings for IPMI using the static IP addressing procedure: Turn on LAN access for the channel found. Beginning with channel 1, run the following command until you find the channel that displays LAN attributes (for example, the IP address): # ipmitool lan print 1 If ipmitool is not communicating with the BMC, then review the section Configuring the BMC and ensure that the IPMI driver is running.Įnable IPMI over LAN using the following procedureĭetermine the channel number for the channel used for IPMI over LAN. Verify that ipmitool can communicate with the BMC using the IPMI driver by using the command bmc info, and looking for a device ID in the output. The following is an example of configuring BMC using ipmitool (version 1.8.6). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |